1. Install "Plastics Insight 6.1", including "Product Security"
2. Optionally install "CAD Doctor 3.0" & "Magics STL Expert 3.0", "Design Link 5.3"
3. Stop "Moldflow Product Security"  and "Plastics Insight 6.1 Job Manager" service if it runs.
4. Put MF2007_fix.exe to "Program Files\Moldflow\Product Security\" and run it there.
5. Put MF2007_fix.exe to "Program Files\Moldflow\Plastics Insight 6.1\bin" and run it there.
6. If you done #2, run MF2007_fix.exe in:
	"Program Files\Moldflow\CAD Doctor 3.0\bin",
	"Program Files\Moldflow\Design Link 5.3\bin",
	"Program Files\Moldflow\Design Link 5.3\Backup\pre_5.3000\bin" (depending on updates installed)
7. Put mfpsd.exe & keyfile to "Program Files\Moldflow\Product Security\"
8. Start "Moldflow Product Security" service and wait some time (1 min), or reboot

Warning: set your firewall to block any internet connection of MF products.
In order to desactive 'Performance Logging': File -> Preferences ->Internet ->Upload:never



cad-doctor-300安装后是日文版的

进入CAD Doctor 3.0\config

打开CadDoctor.ini

在
[System]
; Stack size while serializing (MB)
StackSizeAtSerializing=250
UseThreadForSerialize=False
加上一行
Locale=English 
我大致讲下安装步骤:
先安装MPI主程序，商业版本或者企业版本等等任意都可以，建议安装企业版本，后面的全部默认安装就可以，所有安装完毕后，正式开始破解，直接用鼠标点击“我的电脑”，打开“管理”里面的“服务”选项，找到里面的“Moldflow Product Security”和”Plastics Insight 6.1 Job Manager“这两个服务，先停用，如果有杀毒软件，也请暂时停用； 
然后，把破解包里面的MF2007_fix.exe 放到MPI的安装路径 "Program Files\Moldflow\Product Security\"里面，运行MF2007_fix.exe 
再把MF2007_fix.exe 拷贝到 "Program Files\Moldflow\Plastics Insight 6.1\bin" ，然后运行MF2007_fix.exe 
如果还安装了CAD Doctor 3.0也把MF2007_fix.exe  拷贝  "Program Files\Moldflow\CAD Doctor 3.0\bin",然后运行他；
把破解包里面的 mfpsd.exe 和 keyfile两个文件拷贝到 "Program Files\Moldflow\Product Security\"里面，直接覆盖原始文件；
然后启用前面停止掉的“Moldflow Product Security”和”Plastics Insight 6.1 Job Manager“这两个服务，等1分钟，就可以运行MPI主程序；
CAD Doctor 3.0默认安装后是日文版本的，按照前面我贴的安装方法就可以修改成英文版本；
另外，为了防止MPI软件启动后自动链接到MPI网站下载新的补丁造成破解程序失败，在第一次启动MPI软件后，在文件菜单里面，把Internet 里面的连接到MPI的相关选项全部禁用。